Characteristics and sound properties
Soon after its launch, the VOX 200 became one of the most popular and successful high-end kits. Several excellent tests in numerous specialist magazines have demonstrated that this system is at a quality level normally expected of far more expensive candidates. We were asked whether it was possible to fit these cabinets with much cheaper loudspeakers and still get good results.
At the lower frequency end, we replaced the AL 200 8 OHM with the W 200 S 8 OHM and also took out the TI 100 8 OHM mid-range loudspeaker, replacing it with two W 100 S 8 OHM. We left the G 20 SC 8 OHM dome tweeter unchanged. Initial tests showed that only a slight adjustment to the crossover were required. In terms of sound quality, the modified VOX put up an excellent showing in comparisons with the original.
Technical Data:
|
Rated power | 75 W |
Maximum power | 115 W |
Nominal impedance Z | 4 Ohm |
Frequency response | 35–30000 Hz |
Mean sound pressure level | 82 dB (1 W/1 m) |
Cut-off frequency | 200/3000 Hz |
Principle of Housing | Bassreflex |
Net volume | 40 l + 3,5 l |
Outer dimension height | 1000 mm |
Outer dimension width | 200 mm |
Outer dimension depth | 350 mm |
Component parts list for 1 box
The kit includes all the components listed here but not the cabinet.
Tweeter | G 20 SC 8 Ohm | 1 pc. |
Midrange | W 100 S 8 Ohm | 2 pcs. |
Woofer | W 200 S 8 Ohm | 1 pc. |
Crossover | Crossover VOX 200 LIGHT | 1 pc. |
Terminal | BT 95/75 | 1 pc. |
Damping material | Polyester wool | 3 bags |
Countersunk screws | 3.5 x 25 mm | 23 pcs. |
Material for speaker covers | width 50 cm | 0.5 m |
Cable | 2 x 2.5 mm² | 2.5 m |
| 2 x 1.5 mm² | 1.5 m |